ACURA COMPONENT LOCATION

1988-1990 LEGEND

SRS Monitor Unit & Main Unit - Under Center Console
Right and Left Crash Sensors - At the Right and Left Inner Bumper
Driver Side Air Bag - At Steering Column

1991-1995 LEGEND (coupe and sedan)

SRS Unit - At rear of center console, between 2 front seats
Pretenssioners - At center support window beams

1992-2001 VIGOR and Integra

SRS Control Unit - Under front part of center console

1997-99 2.2CL, 2.3CL, and 3.0CL

SRS Control Unit - Under front of center console, towards front of shifter

All 3.2TL, 2.3TL and 2.5TL 

SRS control unit - at the mid front part of center console

1996-1998 3.5RL

SRS Computer - at lower front of center console
Driver seat belt tenssioner - On window sill/support tower

2001-2011 3.2CL   1999-2006 3.5RL    All RSX, MDX, and 2000-2006 3.2TL

SRS control unit - at lower/front part of center console
Seat Belt Tenssioner - inside window sill/support tower, close to floor
Driver and passenger air bag - On inside of the front seats backrest, along outer edge
OPDS Sensor or Occupancy Sensor - inside the passenger front seat backrest
Passenger and Driver side crash sensor - at the bottom side of vehicle, bolted to floor
MES or memory erase signal connector - at the driver's kick panel
DLC - at back of ash tray

NOTE: All ACURA/HONDA SCS/MES Service connectors are located under the glove box or at the driver side under dash fuse box.
On latter models OBD II systems, SRS is diagnosed through PIN 9 of DLC connector. Follow directions from the How to access codes button text.
------------------------------------------------------------------------------

HONDA Component Location 

All Models 1990 - 2011 (including SUVs) 

* SRS module/computer - Lower front part of center console, close to floor. 
* Side airbag - Inside the front seat backrest 
* Crash sensors - behind front bumper. 
* SCS (Service Check Connector) - May be located at either side of the lower part of the glove box. 
* MES (Memory Erase Connector) - located at the lower left fuse box. Usually plugged to an empty hole at the fuse box. 

NOTE: All ACURA/HONDA MES Service connectors are located under the glove box or at the driver side under dash fuse box.
On latter models OBD II systems, SRS is diagnosed through PIN 9 of DLC connector. Follow directions from the How to access codes button text.